Is this heat resistant and reptile safe? View answer
Asked 5 ´years ago
What kind of gloves should you wear while applying? View answer
Asked 5 ´years ago
I purchased some USFloors oiled engineered flooring from your company a couple years ago and I was curious if you recommend any of the oils I see listed on your site for reapplying another oiling to this particular type of flooring? I know WOCA is mentioned a lot and I have been using WOCA cleaner and oil refresher for ongoing maintenance. Thank you! View answer
Asked 5 ´years ago
Directions for how much solution to what amount of water? View answer
Asked 5 ´years ago
Will this work for sealing concrete tiles on a bathroom floor? View answer
Asked 5 ´years ago
Will this work on a resin fountain? Is it safe for birds View answer
Asked 5 ´years ago
Is it waterproof for an unventilated bathroom ceiling? View answer
Asked 6 ´years ago
Is this safe to use if my wife is pregnant? View answer
Asked 6 ´years ago
I plan to paint over some oak wood trim. I will give it a light sanding first as it is covered in a glossy finish. Would this primer work? I see it says it is for wood, but then later mentions it's not recommended for certain woods. I don't know much about tannins. What would you recommend I use before paint. (I plan to use AFM for the paint.) View answer
Asked 6 ´years ago
I'm trying to decide between ECOS and AFM paint. We are moving into a house and plan to paint all the walls. I don't know what they are currently painted with. What I want is just something completely non toxic. I plan to go white. Any recommendations one way or the other? View answer
Asked 6 ´years ago
How big is a sample? View answer
Asked 6 ´years ago | Paints & Primers
Does the Marmoleum Click Cinch Loc make a clicking or tapping sound when walking on it? I have looked at floating vinyl plank floors and don't like the sound they make, even when backed with cork or foam. In the past, we used original Marmoleum squares glued on a concrete floor and it was rock solid for 20+ years, but this will be on a newly built OSB floor and we'd prefer not to glue. Thanks for any advice! View answer
Asked 6 ´years ago
What sealant for cork flooring that is non toxic do you sell? View answer
Asked 6 ´years ago | Cork Flooring
Can this be used for shower stall walls? View answer
Asked 6 ´years ago
How much air does it remove when operating? View answer
Asked 6 ´years ago
Can I use this product to seal children's toys? View answer
Asked 6 ´years ago
I would like to order carpet for stairs. Can I order it pre cut? View answer
Asked 6 ´years ago
What can I use to remove excess M1 sealant on my metal roof? View answer
Asked 6 ´years ago
can this be used over a door stained with minwax product? View answer
Asked 6 ´years ago
Is it good for treated lumber on the inside of garden beds? View answer
Asked 6 ´years ago
Can ants get through this caulking compound? View answer
Asked 6 ´years ago
can i use your cork panels to soundproof a wall? View answer
Asked 6 ´years ago | Cork Flooring
What does a gallon cost and what is the shipping cost? View answer
Asked 6 ´years ago
what's best method to cut ...is sharp utility knife the way? View answer
Asked 6 ´years ago
I ordered a new cast iron radiator (steam radiator) which comes pre-primed by the manufacturer. They said that without painting it with a "Non alkalized oil based enamel" the radiator would be off-gassing toxins and it Shouldn't be used until it's painted. Would this plus normal AFM paint work for this issue? I don't want toxic fumes/off-gassing in my baby's room where the new radiator is going. View answer
Asked 6 ´years ago
how do i see the colors on this website or order samples? View answer
Asked 6 ´years ago
can I get a sample so I can tell if the color will work? View answer
Asked 6 ´years ago | Cork Flooring
How do you cut it? View answer
Asked 6 ´years ago
