Question 1

Hello, I have 1 gallon of the SafeCoat Polyureseal in matte and 1 gallon in satin. I will likely need to use 2 gallons for my project, 1 initial coat and then a second on top. Is it possible to mix the two gallons together and then proceed with my project, or should I use the matte first and then follow it up with the satin? View answer

Asked 4 ´years ago

Question 2

Will this product completely seal off gassing of plywood or ?should I apply a separate seal before the acrylicq gloss View answer

Asked 4 ´years ago

Question 3

I am refinishing a set of 1940s steel cabinets. Two of the base cabinets have what I believe to be linoleum countertops. They are surrounded by stainless steel edging. There is a curve where the flat countertop and the short backsplash meet. Will your product be able to make that curve (perhaps with heat)? The widths of the cabinets are 18" and 30" so there would not be a long section needing to handle the curve. View answer

Asked 4 ´years ago

Question 4

I am looking for products to seal floor and joints of tortoise habitat constructed of wood? View answer

Asked 4 ´years ago

Question 5

Can I use this to seal a very high porosity 1/4in cork floor? Will it fill the small pores in the surface while staying slightly cushy? View answer

Asked 4 ´years ago

Question 6

Can I order a transition piece for this option? View answer

Asked 4 ´years ago

Question 7

The ingredients list linseed oil, then there is reference to this product being flax oil. Which is it? And is there risk of self combustion if left on rags? I believe linseed can combust if not disposed of properly. View answer

Asked 4 ´years ago

Question 8

Would 100-year old oak floors that have just been professionally sanded be considered weathered or relatively non-porous? I'm trying to figure out how much it will cost for 500-600 sq. feet assuming 2 coats will be sufficient View answer

Asked 4 ´years ago

Question 9

Is this waterproof and food safe? View answer

Asked 4 ´years ago

Question 10

Hi. I read one of these answers wrong I think. I'm working on a butcher block countertop. I was planning on using this product. I already have now. But now I've decided I need to stain the countertop. Is it possible to use Rubio Monocoat 2C Oil stain on the wood and apply this on top for extra protection? TIA for your help. View answer

Asked 4 ´years ago

Question 11

Would this be good for an aggregate driveway? And if so, roughly how long does it last? View answer

Asked 4 ´years ago

Question 12

What is R-Value of Forbo Marmoleum Click flooring? View answer

Asked 4 ´years ago

Question 13

Can you use regular floor wax on Marmoleum? View answer

Asked 4 ´years ago

Question 14

do you make these in 12' x 12'? View answer

Asked 4 ´years ago

Question 15

Is this appropriate for a walkout basement (so part on-grade and part below) where summer/fall humidity is often 70 - 80+% and the windows are open? View answer

Asked 4 ´years ago

Question 16

Can the primer be used on an already painted white desk? And can the paint be used after this primer? Or can the paint itself be used without the primer? View answer

Asked 4 ´years ago

Question 17

Is it pest proof? View answer

Asked 4 ´years ago

Question 18

What 100% acrylic colored gloss paint do you sell that would work with this? View answer

Asked 4 ´years ago

Question 19

Can you please explain how it is carbon negative? View answer

Asked 4 ´years ago

Question 20

Is this product used to remove overall odor from a wool carpet? View answer

Asked 4 ´years ago

Question 21

Can water be added to this to thin it for a HVLP sprayer? I looked at the installation guidelines. It doesn't say if thinning the product with water is ok. View answer

Asked 4 ´years ago

Question 22

Will this work for sealing a wooden hot tub? I need a sealer that can be used to seal a fir hot tub I am building. It will be a small single person tub that is drained and filled after each use. I need a sealer that can be submerged in water up to 105 degrees F and not leach chemicals too much. View answer

Asked 4 ´years ago

Question 23

Hello, used 2 coats on teak and mahogany bench swing...love the product, the way it goes on, no awful smell all great. Question: I noticed after several weeks the wood grain was raised considerably and felt dry. We tested with water and it does bead up. Is it typical for the grain to raise after application? View answer

Asked 4 ´years ago

Question 24

Can this be used to seal cork wall tile? View answer

Asked 4 ´years ago

Question 25

Would this sealer be safe to coat the interior of a concrete candle vessel ? View answer

Asked 4 ´years ago

Question 26

Can I use this solution on a prefinished floor? View answer

Asked 4 ´years ago

Question 27

Can you paint over older paint I have a blue color and want to change to white? View answer

Asked 4 ´years ago

Question 28

Does your paint contain PFAS? View answer

Asked 4 ´years ago

Question 29

Will it hold up to wet conditions? View answer

Asked 4 ´years ago

Question 30

What shade would this oil be on pine? View answer

Asked 4 ´years ago

Question 31

I am highly sensitive to chemicals and need a cleaning solution for a Chenille sofa that recommends dry cleaning only. Could I use something like this instead? View answer

Asked 4 ´years ago

Question 32

I would like a mop, do you carry it? View answer

Asked 4 ´years ago

Question 33

Why are two kits sent? Can you use one for basement and one for most occupied room on first level? View answer

Asked 4 ´years ago

Question 34

Does this function as an air barrier? View answer

Asked 4 ´years ago

Question 35

Can this be used to install quartz countertops? View answer

Asked 4 ´years ago

Question 36

Your specifications say the Wicanders Cork GO, has a beveled edge. But the samples I got, Whim and Charm, are not beveled and the Wicanders website says it is not beveled. I suspect this product does not have a beveled edge. Are your listed specifications a mistake? I would prefer that it not have a beveled edge. View answer

Asked 4 ´years ago

Question 37

I would like to use it on new exterior window shutters, made of cedar boards. I expect we need to use a sealer. What product do you recommend? View answer

Asked 4 ´years ago

Question 38

Is this scratch resistant? View answer

Asked 4 ´years ago

Question 39

How do you think this a wool rug will do with high humidity? Would it feel damp? Smell like sheep? :) Might the wool's high absorption rate lead to mold in the backing? The ambient humidity where I live is 70 - 80% but it's cool enough for the windows to be open. Thank you. View answer

Asked 4 ´years ago

Question 40

Will this glue work to adhere Silicone tubing to another piece of Silicone tubing? Or to other surfaces (Plastic, glass, metal, wood, etc.)? This is a crafting question, not a construction question. View answer

Asked 4 ´years ago

Question 41

What safecoat product can l use over oil enamel? View answer

Asked 4 ´years ago

Question 42

What's the best sealant for untreated pine window frames? View answer

Asked 4 ´years ago

Question 43

Do the larger planks and the smaller size tiles connect in the same manner ? I would like to finish up my last narrow row and the closet with the smaller tiles so as not to have to cut larger planks to fit a narrow row. Hard to do with my table saw. View answer

Asked 4 ´years ago

Question 44

Hi. Can you use this to texture walls? We need to texture some spots. View answer

Asked 4 ´years ago

Question 45

Is this preferred over redgard in terms of toxicity? View answer

Asked 4 ´years ago

Question 46

What can I use that's a food safe hard sealant on a painted serving tray? View answer

Asked 4 ´years ago

Question 47

I see that to get the best natural wood look, I should use gloss for first coat and then the satin. I have your Safecoat Hardseal product in gloss. Would this be ok to use with the acrylaq? Do I even need the acrylaq or should I order the Safecoat Hardseal in satin? It's for a kitchen table. View answer

Asked 4 ´years ago

Question 48

Can this product go on a tile wall? I have marble 12" tiles (1/8" grout lines) that I plan to cover with wallpaper. Thank you. View answer

Asked 4 ´years ago

Question 49

Does this carpet pad stay put, or does it need something to hold it together (like sewing it, or seam tape)? View answer

Asked 4 ´years ago

Question 50

We bought a house from a smoker and are renovating. Can I use this over killz to seal off vocs from the killz? View answer

Asked 4 ´years ago

Browse by Topic