Can I use AFM Safecoat dura stain, on a Room divider that's solid wood? View answer
Answer posted 2 years ago
Is this product antibacterial or a disinfectant? View answer
Answer posted 2 years ago
I have a cinder block foundation with a cement based parging that had a color added to make it black. The color turned out to be a darker grey. I believe it was a powder that was added to the parging mix. Can we use the Silacote to get the black color we originally were looking to achieve? Also, if the Silacote is suitable, which type would be recommended, smooth or textured? View answer
Answer posted 2 years ago
We've stripped our exterior stone walls with Peel Away followed by pressure-washing. The paint coatings were peeling and we assume were not of the breathable type. The result is a partially "clean" wall. Is there a breathable coating, perhaps semi-transparent, to even out the uneven remaining early paint finish on of the wall? Any recommendations are appreciated. View answer
Answer posted 2 years ago
Do you have marble tile sealer? View answer
Answer posted 2 years ago
What makes this flooring waterproof? Is it free of all PFAS? View answer
Answer posted 2 years ago | Cork Flooring
Do you need to tape the underlayment at the perimeter of the room or just at the seams? View answer
Answer posted 2 years ago
What kind of underlayment does it need? View answer
Answer posted 2 years ago
Can this be used under a glue down floor? View answer
Answer posted 2 years ago
Hi, I have just moved into a rental property that has had new carpet and underlay installed about 2 weeks ago. I have MCS and don't think either carpet or underlay is low VOC. Can I treat just the carpet with this system or will I need to also treat the underlay? Ideally, I wouldn't have to remove the carpet and can fix the problem by sealing just the carpet itself. View answer
Answer posted 2 years ago
Hi, when this gets wet does it get slippery? View answer
Answer posted 2 years ago
How thick is the wear layer? View answer
Answer posted 2 years ago | Cork Flooring
Can this be used with a glue down floor? View answer
Answer posted 2 years ago
Which side goes down? View answer
Answer posted 2 years ago
What do you recommend to apply this paint? Brush or sprayer? View answer
Answer posted 2 years ago
Is this safe to use to glue cutting boards? Is it FDA-approved for indirect food contact? View answer
Answer posted 2 years ago
Is this safer than Titebond III, in terms of VOC? View answer
Answer posted 2 years ago
Can this be used to apply the Polywhey Finish? View answer
Answer posted 2 years ago
Does the floor need to be level to use marmoleum? Thinking of putting in basement View answer
Answer posted 2 years ago
Answer posted 2 years ago
What is the height of this carpet? View answer
Answer posted 2 years ago
I'm confused about the VOC content. Here it's listed as 35 g/L, the SDS sheet shows 14.67 g/L, then the ingredients list seems to apply 0 g/L and 19 g/L at 240 F. So what is it exactly? Why are there completely different numbers reported all around on the product page? View answer
Answer posted 2 years ago
Is this safe for food contact? View answer
Answer posted 2 years ago
Hi! We have click type marmoleum that got water damage and mold in an area. Can we pull up just a 5 foot area and install the roll flooring? Will it be the same height? Do I need to cut and replace the underlayment? Thank you! View answer
Answer posted 2 years ago | SAMPLE - Forbo Marmoleum Composition Sheet (MCS), Lemon Zest
Can this primer go on ABS plastic? If so, can I put NovaLink FP on top of the primer? View answer
Answer posted 2 years ago
Answer posted 2 years ago | Cork Flooring
Will there be seams? View answer
Answer posted 2 years ago | SAMPLE - Forbo Marmoleum Cocoa, Panna Cotta - Sheet
Not treated with Aluminium oxide ? View answer
Answer posted 2 years ago
Does this work with a flatweave cotton rug? View answer
Answer posted 2 years ago
I'm thinking of getting an Ikea wardrobe cabinet (Pax), but the sides of the shelves are exposed particle board. The inside of the sidewalls have peg holes for the adjustable shelves. These holes (approx. 1/4" round and deep) are also exposed particle board. Which AFM product would be best to use to seal these? In addition, if I decide to seal the whole cabinet (the Ikea description says it is made of fibreboard and paper foil) which AFM product would I use? Are AFM sealer products completely inert when dry? (i.e. absolutely no smell) View answer
Answer posted 2 years ago
Our goal is to have a floor that has good cushioning, insulation, soundproofing and can hold up to furniture and foot traffic (2nd floor bedroom, office, playroom). I'm torn between Cork or Marmoleum.I'd like your opinion on the durability of the Go-cork plank product. Indenting, fading and non-waterproof seem to be the main marks against it. Can you interpret these numbers? From what I can see on this website, the Cork has IIC 58, STC 54, r-value: ? compared to Marmoleum IIC57, ASTM E 492, STC ?, r-value 0.53.Am I to understand that marmoleum plank has almost similar properties to Cork plank? View answer
Answer posted 2 years ago
What backing material would you recommend for a desktop using the furniture marmoleum? View answer
Answer posted 2 years ago
Does KERDI have phthalates in it? View answer
Answer posted 2 years ago
Will this bond to ABS plastic? What about PVC? View answer
Answer posted 2 years ago
