Question 1

First, I am working with raw, unfinished wood. Do I need to use a different penetrating oil, such as your hard oil, first? The description seems to think so, but most of the recommendations in the answer sections do not. Second, can a normal paint be applied over top of this finish? I'm trying to find a safe way to make wooden cake toppers. My thought is to treat the entire topper with this to seal it, and then paint the top portion as usual leaving the posts where food may contact with just the food grade finish. View answer

Asked 6 ´years ago

Question 2

Hi there. I have an old coffee table I have sanded and I want to protect it and make it look good. Is this product a good fit? View answer

Asked 3 ´years ago

Question 3

Safe floor adhesive to use around birds? View answer

Asked 5 ´years ago

Question 4

Can you get a finish for this other than recycled PET? I would prefer a non-plastic finish. View answer

Asked 4 ´years ago

Question 5

Is NovaLink 35 All-Weather Construction Sealant safe to use in a plumbing system? I need to seal a leaky valve. View answer

Asked 5 ´years ago

Question 6

what is the lead time for orders? View answer

Asked 4 ´years ago

Question 7

Is this safe for my boa constrictors huge terrarium that I'm building and was seeing if it is safe for him and safe for the wood not to mold and /or warp the wood because of high humidity? View answer

Asked 5 ´years ago

Question 8

I have read that cork flooring does not do well in places where there are extremes in temperature. We would like to lay cork over a tile floor in Phoenix Arizona where there can be 30 degree changes in temperature in one day, and temps ranging from the 40 in the winter to 115 in the summer. Humidity is usually low - it is 17% today. Of course, our homes are AC/heat controlled, but failures can happen. Will cork floors work in this setting? View answer

Asked 4 ´years ago

Question 9

Does the paint contain kaolin? View answer

Asked 5 ´years ago

Question 10

Can you clean these floors with bleach? View answer

Asked 5 ´years ago

Question 11

Do we have to oil the Kahrs American Naturals right after installation, or just when we want to refresh it? View answer

Asked 1 ´year ago

Question 12

If I want to apply a 2nd coat to light wood, do I just wait 48 hours or is any other prep. needed (already sanded and water popped before my 1st coat)? View answer

Asked 1 ´year ago

Question 13

Can this be used on plastic? View answer

Asked 4 ´years ago

Question 14

Hello, could your transitional primer and no VOC paint be used over rustoleum on a washer lid? Are they waterproof? View answer

Asked 4 ´years ago

Question 15

Can your grout sealer seal in the mastic fumes that was used to adhere my backsplash tile? View answer

Asked 5 ´years ago

Question 16

My husband and I recently stained a platform bed with Minwax Oil Based stain and are desperately looking for something to block the VOC�s from off gassing. Please let me know if this will work and if not, if there is another recommendation? View answer

Asked 5 ´years ago

Question 17

Is this the same type of oil in the Kahrs Satin Oil? View answer

Asked 4 ´years ago

Question 18

I need to seal off-gassing from the cabinets and glossy walls in my travel trailer. I also want to paint the cabinets and walls too. If I used the matte finish, would it be a good primer? Would the paint do well on top or should I use a different safecoat product to put over the paint and use a regular primer? View answer

Asked 5 ´years ago

Question 19

please could you let me know which size is the spray option? View answer

Asked 6 ´years ago

Question 20

Can you use this on metal with an epoxy finish? View answer

Asked 5 ´years ago

Question 21

I have oak that was previously treated( unsure with what it was treated with but it does seem like polyurethane) what is best course of action for refinishing oak? This project is in the bathroom in a high moisture area. Thank you View answer

Asked 8 ´months ago

Question 22

Will this product work for building a salt wall with Himalayan salt bricks? View answer

Asked 4 ´years ago

Question 23

In NOTE-5 under Vermont Natural Coatings PolyWhey Ext. Stain, it says the stain can be used over oil finish and stain. Can I use this stain over Clear Penetrating Oil? Our outdoor cedar furniture just received their new fresh Safecoat penetrating oil coat. So we sand them a little just to roughen the surface? Or sand down to raw wood? View answer

Asked 4 ´years ago

Question 24

Do I need a cushion or padding layer under the installation? View answer

Asked 1 ´year ago

Question 25

Is this underlayment ok to use with radiant heated floors? View answer

Asked 3 ´years ago

Question 26

After I apply the 2-4 coats of Hard Seal to a kitchen cabinet, will I need to re-apply the product down the road? View answer

Asked 4 ´years ago

Question 27

Can this product be mixed in with the grout prior to installation instead of being applied on the grout lines after the tile is installed & dries? View answer

Asked 5 ´years ago

Question 28

i have a round table that is a 48" wide and was trying to not have a seam. can i order a special cut? View answer

Asked 2 ´years ago

Question 29

Do you have a deglosser? I want to paint over gloss finished walls, moldings and wood stair rails. View answer

Asked 5 ´years ago

Question 30

Is this primer appropriate to use on wood that will be outdoors in freezing winters and humid summers? View answer

Asked 5 ´years ago

Question 31

can this be put on top of a previously finished maple wood table? I'm not sure what kind of finish is on it now? View answer

Asked 4 ´years ago

Question 32

Do I have to sand my maple wood table first before I use this product? View answer

Asked 4 ´years ago

Question 33

does this seal in toxic vocs like the water based product AFM Safecoat Acrylacq? View answer

Asked 4 ´years ago

Question 34

can you put this on over Safecoat Hardseal? View answer

Asked 3 ´years ago

Question 35

I'm looking to seal formaldehyde emissions from the back of a mirror which is made of MDF that�s painted over. Will SafeSeal or Hard Seal work best for this purpose? View answer

Asked 2 ´years ago

Question 36

How do you know what the color numbers stand for? View answer

Asked 1 ´year ago

Question 37

Are there any adhesives used in the construct of the actual cork flooring? Not looking for a glue to install but wondering if there are adhesives in the cork floor panels? View answer

Asked 4 ´years ago

Question 38

can this be used for sealing aquariums/ vivariums (plywood) and to seal painted foam (backgrounds)? View answer

Asked 6 ´years ago

Question 39

Could this be used to line the floor of a coop (with bedding on top)? I'm assuming this is safe around animals once properly applied/cured? View answer

Asked 3 ´years ago

Question 40

Would this Waterstop or the watershield be better to use on slate veneer shower walls? The veneer has a waterproof resin backing, but I'm still wanting something to help the stone repel water View answer

Asked 5 ´months ago

Question 41

What kind of adhesives would stick to this? I see that you can use thinset and tile over, but we are using a stone veneer product for our shower walls and need to glue it up. A two part epoxy adhesive is what is recommended by the manufacturer of the veneer. Would an epoxy based adhesive adhere to this product? View answer

Asked 5 ´months ago

Question 42

Can this be used under other brands of paint? I already purchased zero voc latex paint from our local hardware store, but they don't carry a zero Voc primer so I am looking to order something I can use under the paint I already purchased. View answer

Asked 5 ´months ago

Question 43

Would this be safe to use over Amorim waterproof cork flooring (cork look)? View answer

Asked 6 ´months ago

Question 44

Are there installation instructions for using this as a kitchen countertop rather than flooring? I've seen it suggested that this is an acceptable use for this product View answer

Asked 7 ´months ago

Question 45

Can this product be used on ceramic tile floors ? View answer

Asked 5 ´years ago

Question 46

Can a click floor be installed over an existing ceramic tile floor without removing tiles? View answer

Asked 4 ´years ago

Question 47

I'm working from home a lot now, because of Covid. Wondering how this floor would hold up in a home office - would there be indents from sitting all day in a desk chair? Would those add up over time to the area under the desk being indented/compressed? View answer

Asked 5 ´years ago

Question 48

it's for my floor. How many tiles come in a box and how much is a box? Thanks View answer

Asked 4 ´years ago

Question 49

Do you have or can you custom design marmoleum that looks like pine or cedar in color and 12�x36� to look like wide wood planks? Need 1296 sq. ft for interior and 432 sq ft for porch to look like a deck View answer

Asked 4 ´years ago

Question 50

What is the best sealer to use for granite kitchen countertops? View answer

Asked 5 ´years ago

Browse by Topic