Question 1

I have some new Sauder furniture that has raw particle board on the edges. Even the wood parts that have been finished have the odor. Should I use the safe seal on the raw edges and the hard seal on the finished parts, or can I use the hard seal on the raw edges and the finished parts? I just need to seal in so no off gassing. Thank you. View answer

Asked 3 ´years ago

Question 2

We used radon seal and are looking for a topcoat waterproof layer. We have also previously sealed cracks and old carpet tacking holes with a silicone based caulk. Will this product hold up to high traffic and constant pressure from carpet and will it adhere after using radon seal? View answer

Asked 1 ´year ago

Question 3

Based on a previous review, it seems that the Dye used in this product rub's off when handled. Is this true and if yes, for how long can I expect this to happen ? View answer

Asked 4 ´years ago

Question 4

I have primed & painted dining room chairs with a water based enamel. Will the safecoat protect the paint on the chairs? Thank you View answer

Asked 3 ´years ago

Question 5

Is this ok for high humidity areas like a house on the beach? what about the silicone underlayment? I was really looking for a non toxic no smell paper, but cannot seem to find. Thank you! View answer

Asked 2 ´years ago

Question 6

I bought Safecoat Acrylacq and want to be able to wash brush at the end of each application. I don't have the cleaner it recommended. What can I use to clean the brushes? View answer

Asked 1 ´year ago

Question 7

I'm wondering if this will hold up to regular steam and not leach? I'm trying to seal a wooden yoni steam seat and would prefer to seal rather than oil. Unless you think oil is better for this purpose? Thx! View answer

Asked 2 ´years ago

Question 8

Roughly how long does it take for the paint to become saturated & need to be recoated, & how do you know when to repaint? The air purifying brochure talks about this but doesn't give any sense of how often this might be or how you would know. Thank you! View answer

Asked 2 ´years ago

Question 9

Which SAFECOAT product should I use to coat over all the new OSB in our new house building? Thanks! View answer

Asked 2 ´years ago

Question 10

Is it ok to use a water-based stain after using this product? Thank you! View answer

Asked 3 ´years ago

Question 11

Is it ok to install the floor around a drain (in our basement) or what do you suggest? Along the bottom of the wall by the drain there is actually a gap that allows for drainage from the washer/dryer and utility sink in the nearby room. View answer

Asked 5 ´years ago

Question 12

We moved into a house with an old carpet and we know for a fact the prior owners used lots of chemicals on their lawn. They left a garage full of them. Is this something we can use to clean and "encapsulate" any chemicals left in the carpet or is the only way to replace the whole carpet? Thank you! View answer

Asked 5 ´years ago

Question 13

How does this compare with the Kilz primer for mold that my contractor wants to use in terms of health/environmental impacts? View answer

Asked 5 ´years ago

Question 14

Is it ok to use this on something that had been previously stained with linseed oil several years ago? Thank you! View answer

Asked 3 ´years ago

Question 15

Ok to use this to paint hardwood furniture that was previously stained (I don't know if it was an oil or water based stain)? View answer

Asked 3 ´years ago

Question 16

Will this seal in the odour of new untreated sawn wood? View answer

Asked 2 ´years ago

Question 17

Does it have latex or natural rubber? View answer

Asked 6 ´years ago

Question 18

I bought a cabinet. Not sure what kind of wood it is or if it is a laminate. Cabinet said "Warning: Formaldehyde gases". Can this product be used to eliminate the gases from formaldehyde? View answer

Asked 5 ´years ago

Question 19

I bought a cabinet with warning CA proposition 65. Will Natural Safecoat Clear Penetrating Oil or Bioshield stop gases from being emitted into the house? View answer

Asked 5 ´years ago

Question 20

I am looking for a wood filler to go between cracks on a wood floor that can handle some expansion/shrinkage. The floor fluctuates in super dry winter and humid summer. Will this wood putty be flexible after drying? View answer

Asked 3 ´years ago

Question 21

Is the finish for this flooring made with water-based polyurethane or oil-based polyurethane? View answer

Asked 2 ´years ago

Question 22

Can this be used over wallpaper? Will it be durable and washable? View answer

Asked 4 ´years ago

Question 23

Is it mildew resistant? View answer

Asked 5 ´years ago

Question 24

I have already installed a grout that does not contain Portland cement. What no or low VOC sealer do you recommend? I prefer no VOC. View answer

Asked 4 ´years ago

Question 25

For already primed doors do I need transitional primer or ecolacq sandable primer? View answer

Asked 4 ´years ago

Question 26

Can polyureseal be used over raw pine doors to seal in the odor and toxins? Can those doors then be painted with AFM safe coat primer and paint at a later time? View answer

Asked 4 ´years ago

Question 27

Can this be used after staining the wood? View answer

Asked 6 ´years ago

Question 28

M-1 nearest availability in zip 95476 for will call?? View answer

Asked 3 ´years ago

Question 29

have you used this product on yellow cedar and what were the results???? View answer

Asked 4 ´years ago

Question 30

How thick a layer can you create with this product? I want to use it over an uneven surface of a collage art work and create a smooth level protective layer. View answer

Asked 5 ´years ago

Question 31

We coated our paperstone counters with bioshield counter finish. 2 years later the finish has spots on it that seem like something dissolved the finish. Do we need to sand the counter top before reapplying the bioshield? View answer

Asked 9 ´months ago

Question 32

What are the instructions for applying Rubio Monocoat to pine molding and not a floor? View answer

Asked 5 ´years ago

Question 33

I have 110 sf wall to laminate...how many tubes do I need? View answer

Asked 5 ´years ago

Question 34

How fast does this work? It is for an office area - where the hardwood floors were just coated and the off gassing is just horrible! How long in between coats do you have to take? How long does it take to dry? View answer

Asked 6 ´years ago

Question 35

Does this function as an air barrier? View answer

Asked 4 ´years ago

Question 36

I am looking for an eco friendly paint that I can use in my rented room. Can you repaint over clay paint with latex? I am worried about making the room hard to repaint for the landlord/next tenant. View answer

Asked 2 ´years ago

Question 37

What is the weight of each size block? View answer

Asked 4 ´years ago

Question 38

How frequently do you reapply the oil wax finish in a wood flooring application? Especially in the more trafficked areas like entry hallways? View answer

Asked 6 ´years ago

Question 39

Is the polyurethane good to use on wood and cork floors? View answer

Asked 3 ´years ago

Question 40

I'm curious where we can see what each color looks like? Thanks! View answer

Asked 5 ´years ago

Question 41

I have original wood floors with an oil base finish. I had a floor furnace taken out and am wondering if this finish will at least somewhat blend with the new wood being placed? View answer

Asked 6 ´years ago

Question 42

it says to tape seams with duct tape. am I reading that right? View answer

Asked 3 ´years ago

Question 43

if you use glue down do you still need underlayment? View answer

Asked 3 ´years ago

Question 44

Can one person walk on the floor two days after applied ? View answer

Asked 1 ´year ago

Question 45

I had a pipe break during a freeze and cork floating floor is warping, Can this product withstand a brief flood without warping? View answer

Asked 1 ´year ago

Question 46

With the click-on system do you need the underlayment? View answer

Asked 4 ´years ago

Question 47

This carpet has a latex backing. Does it have off-gassing odors? I wanted the most natural and non-toxic carpet available (i.e. Earthweave), but it's way out of my budget. So, I'm considering JMish Alfa, but the synthetic latex backing makes me uneasy. View answer

Asked 4 ´years ago

Question 48

is this clear? View answer

Asked 4 ´years ago

Question 49

Does it kill mold? View answer

Asked 3 ´years ago

Question 50

Can I use this on a rusty steel industrial door that I would like re-using as a interior closet door? Trying to find something to just seal the rust to the door so it doesn't flake off in the house. View answer

Asked 5 ´years ago

Browse by Topic