Answer
Sep 16, 2019 - 04:44 AM
SURFACE PREPARATION:Sand wood smooth with 120 grit sandpaper to open wood grain. Surface should be completely dry before application. Before using, stir Safecoat Naturals Oil WaxFinish well, then apply as is stirring occasionally during use. APPLICATION:Apply with a brush, roller, pad or sprayer. ALWAYS conduct several test patches or a testcoat to ensure compatibility and acceptability of appearance before application to the entire surface. Although Safecoat Naturals Penetrating Oil contains no formaldehyde or other toxic ingredients and requires no special protective equipment to apply, assure good ventilation throughout use and while product is drying. Protect adjacent surfaces not to be coated, including plants. Apply one even coat, working with the grain, using a premium quality, wide bristle brush, a roller (followed immediately by backbrushing), or an airless sprayer with a 0.11 or larger tip and 700 - 800 psi (lowest pressure to achieve a full wet spray without atomization).Allow finish to penetrate for 10 - 15 minutes, then APPLY A SECOND COAT WHILE FIRSTCOAT IS STILL WET. Allow the second coat to penetrate for 10-15 minutes, then wipe off all oil that has not penetrated into the wood with a clean, absorbent cloth. Do not allow oil to puddle. If desired and wood is still absorptive, another coat maybe applied after 24 hours, but note that additional coats will inhibit the ability to absorb stains or hard surface sealers. Buffing is highly desirable for a smoother more even finish but it is not required. Note: these instructions are intended to be general only and not exhaustive. The applicator should determine what preparation and techniques are best suited to the specific surface.
