Order as many floor samples as you like and we'll ship all samples to you for free! You may then return them, within six months, and receive a refund for all returned samples. Please note: We do not reimburse for return shipping costs.
This product should not freeze or it will not perform properly.
We will not ship this product over a weekend. You may opt to ship anyway, at your own risk, but this must be ordered via phone with a GBS eco-advisor. 800.405.0222
AFM Safecoat Ecolacq is a tintable high gloss lacquer that's non-toxic and has no off-gassing of toxic chemicals. It's a perfect water-based substitute for high solvent lacquers that can be applied to most woodwork such as cabinets, furniture, doors, windows, etc. This is a tintable version of AFM Safecoat Acrylac.
Like most lacquers, Ecolacq will produce a beautiful glossy finish when sprayed, but without the nasty odors. It can be tinted to any AFM color and has the appearance of high end gloss paint. It is extremely durable and is water and scratch resistant.
Safecoat Ecolacq also is an encapsulating sealer that will block VOC emissions from chemicals that have been applied beneath its surface. This is primarily for water based finishes, but can work over oiled surfaces if they have dried long enough, i.e. usually 2-3 weeks or more, depending upon temp and humidity levels. We always recommend testing a sample first before using to be sure of adequate bonding and for your own tolerance levels.
*NOTE 1: Paint Samples are in White Untinted color only.
*NOTE 2: Color swatches may appear different on different monitors and browsers. Computer monitors are not all calibrated the same and digital color reproduction varies. It is not possible to guarantee our online colors will look the same on all computers, therefore we do not guarantee that what you see accurately portrays the color of the paint you will receive. Please order a swatch book to be sure of the color you are ordering.
State Nexus Fee may apply A state nexus fee will be applied to this item if drop shipped to the following states: California, Wisconsin. We're sorry for the inconvenience. Click here to read more about the state nexus fee.
Residential Finish Wear
Commercial Finish Wear
Forest Stewardship Council (FSC)
FSC Chain-of-Custody #
Indoor Environmental Quality/4.2 Low-Emitting Material/ Paints and Coatings: 1 point
LEED® Regional Materials Zip Code
Meets or exceeds California South Coast Air Quality Management District (SCAQMD) requirements, SCS Gold
Always have adequate ventilation. Intermix (boxing) all containers of the same sheen to ensure gloss uniformity before applying. Before using, mix coating thoroughly by gently stirring or rolling container to avoid air bubbles. Be sure to stir product thoroughly every 20 minutes during application. Do not shake container. Pour material to be used into another container before applying coating to avoid contaminating main container. Then apply as is, using a quality nylon brush, pad applicator, or unheated spray applicator. Apply liberal coats, keeping a good wet edge and avoid overbrushing. In most cases, a minimum of 2 coats is required, depending on the surface. When spraying, use a .015 tip or smaller. Apply thin even coats when spraying rather than heavy coats which will tend to sag. If spray pattern begins to dryspray, reduce air pressure and increase material flow to surface. Use aluminum oxide or silicon carbide sandpaper to sand between coats. Use a damp, dust free rag after sanding to remove dust particles. For best results, this product should not be reduced. Use only during low or moderate humidity conditions. Applying product over lightly dampened surfaces can assist in controlling the dry time and obtaining smoother finishes. Note: these instructions are intended to be general only and not exhaustive. The applicator should determine which preparation and techniques are best suited to the specific surface.